HP P2000 Controller Networks Test

This test reports the current status of the network of each controller of the storage system.

Target of the test : A HP P2000 SAN storage system

Agent deploying the test : A remote agent

Outputs of the test : One set of results for each controller in the storage system being monitored

Configurable parameters for the test
Parameter Description

Test period

How often should the test be executed .

Host

The host for which the test is to be configured. Since the storage device is managed using the IP address of its storage controller, the same will be displayed as host. In case of a dual-controller configuration, the IP address of the primary controller will be displayed here.

Port

The port number at which the specified host listens. By default, this is NULL.

Additional Controller IP

By default, this test always connects to the Host to collect metrics. If the Host is unavailable, then the test will not be able to execute. This is because, the Additional Controller IP is set to none by default.

If the monitored storage device has two controllers, then you can configure the test to connect to an alternate controller, if the host is unreachable. For this purpose, specify the IP address of the alternate controller in the Additional Controller IP text box.

User and Password

In order to monitor a HP P2000 SAN storage system, the eG agent has to be configured with the credentials of a user who has been assigned the Monitor role. Specify the login credentials of such a user in the User and Password text boxes. To know how to create such a user, refer to Pre-requisites for monitoring the HP P2000 SAN storage system.

Confirm Password

Confirm the password by retyping it here.

ServidePort

The Management Controller of the HP P2000 storage system provides access for monitoring and management via the HTTP and HTTPS protocols for XML API request/response semantics. To enable the eG agent to access the management controller, invoke the XML API commands, and collect the required metrics, you need to specify the service port on the controller that listens for HTTP/HTTPS requests for XML API semantics. By default, this is port 80.

Timeout

Specify the time duration for which this test should wait for a response from the storage system in the Timeout text box. By default, this is 60 seconds.

SSL

By default, HP P2000 SAN system is not SSL-enabled. This is why, this flag is set to False by default. If it is SSL-enabled, then change this flag to True.

Detailed Diagnosis

To make diagnosis more efficient and accurate, the eG Enterprise embeds an optional detailed diagnostic capability. With this capability, the eG agents can be configured to run detailed, more elaborate tests as and when specific problems are detected. To enable the detailed diagnosis capability of this test for a particular server, choose the On option. To disable the capability, click on the Off option.

The option to selectively enable/disable the detailed diagnosis capability will be available only if the following conditions are fulfilled:

  • The eG manager license should allow the detailed diagnosis capability
  • Both the normal and abnormal frequencies configured for the detailed diagnosis measures should not be 0.
Measurements made by the test
Measurement Description Measurement Unit Interpretation

Health

Indicates the overall health of the network of this controller of the HP P2000 SAN storage system.

 

The values that this measure can report and their corresponding numeric values are tabulated below:

Measure Value Numeric Value
Degraded 0
OK 1

Note:

By default, this measure reports the above-mentioned Measure Values while indicating the network status. However, in the graph of this measure, the same will be represented using the corresponding numeric equivalents only.

The detailed diagnosis of this measure if enabled, lists the time, the name of the management port on the controller, and the reason for the health of the network.