EVA Controller Power Status Test
This test auto-discovers the power supply units on the controller and reports the status of each unit.
Target of the test : An EVA Storage Array
Agent deploying the test : A remote agent
Outputs of the test : One set of results for each power supply on the controller.
| Parameter | Description |
|---|---|
|
Test Period |
How often should the test be executed. |
|
Host |
The host for which the test is to be configured. |
|
Port |
Refers to the port used by the EVA SAN device. By default, it is null. |
|
EVASystemIP |
Specify the IP address of the HP EVA SAN. |
|
ArrayName |
Specify the name of the EVA SAN array that has been configured for monitoring. |
|
SSSULocation |
Install the SSSU.exe software and specify the full path to the install directory of this software here. |
|
Username and |
Specify the user credentials using which the HP EVA array is to be accessed. |
|
Confirm Password |
Confirm the password by retyping it here. |
|
Timeout |
Indicate the duration (in seconds) for which this test should wait for a response from the storage device. By default, this is set to 120 seconds. |
| Measurement | Description | Measurement Unit | Interpretation | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
|
Power status |
Indicates the current status of this power supply unit. |
Status |
The values that this measure can report and the states they indicate are tabulated below:
Note: By default, this measure reports the States listed in the table above to indicate the current state of each power supply. The graph of this measure however, represents the status of a power supply using the numeric equivalents only. |
