EVA Controller to Device Port Status Test

This test reports the current operational mode of each device port on the controller.

Target of the test : An EVA Storage Array

Agent deploying the test : A remote agent

Outputs of the test : One set of results for each device port on the EVA controller.

Configurable parameters for the test
Parameter	Description
Test Period	How often should the test be executed.
Host	The host for which the test is to be configured.
Port	Refers to the port used by the EVA SAN device. By default, it is null.
EVASystemIP	Specify the IP address of the HP EVA SAN.
ArrayName	Specify the name of the EVA SAN array that has been configured for monitoring.
SSSULocation	Install the SSSU.exe software and specify the full path to the install directory of this software here.
Username and Password	Specify the user credentials using which the HP EVA array is to be accessed.
Confirm Password	Confirm the password by retyping it here.
Timeout	Indicate the duration (in seconds) for which this test should wait for a response from the storage device. By default, this is set to 120 seconds.

Measurements made by the test

Measurement

Description

Measurement Unit

Interpretation

Operational mode

Indicates the current operational mode of this device port.

Status

The values that this measure can report and the states they indicate are tabulated below:

State	Value
good or attention or normal	1
Failed or bad	0
Unknown or not available or notinstalled or not_present or unsupported, etc.	2

Note:

By default, this measure reports the States listed in the table above to indicate the current operational state of each device port. The graph of this measure however, represents the status of a device port using the numeric equivalents only.