Pre-requisites for Emulating Email Sending/Receiving Activity
The emulation can be performed only by an external agent. It requires at least one external agent should be up and running in the environment for the emulation to occur.
To simulate the mail sending activity for a sender and receiver in the same location, you need to install and configure a single external agent, and configure this agent to simulate both the email transmission and reception.
In caseyou want to simulate the email communication between a sender in one location and a receiver in another, then you will have to configure two external agents - one per location. For instance, you may want to monitor the email communication between sender email@example.com in Singapore, and receiver firstname.lastname@example.org in California. In this case, you need to install two external agents - one in Singapore and another in California. Then, you should use the agent in the sender's location - i.e., Singapore - to simulate the email transmission, and the agent in the receiver's location - i.e., California - to simulate the email reception.
Note that a single eG external agent can be configured to perform multiple simulations.
For every simulation, two valid mailboxes are required - one for sending emails and another for receiving them. You may want to consider creating a dedicated sender and receiver for monitoring purposes.