Ut Device Services Test

SunRay device services include USB devices connected through USB ports, internal serial ports, and internal smart card readers on the SunRay DTU. After installation of SunRay Server Software, all device services are enabled by default. Administrators can use this test to check whether each of these device services is enabled or not.

Target of the test : A SunRay server

Agent deploying the test : An internal agent

Outputs of the test : One set of results for each device service on the SunRay server monitored.

Configurable parameters for the test
Parameter Description

Test period

How often should the test be executed


The host for which the test is to be configured.


Refers to the port at which SunRay server listens for requests. By default, this is 7010.

Measurements made by the test
Measurement Description Measurement Unit Interpretation

Service status

Indicates whether this service is enabled or disabled.


If the value of this measure is 100, it indicates that this service is enabled. Whereas, the value 0 indicates that this service is disabled. When internal serial service is disabled, users cannot access embedded serial ports on the SunRay DTU. The SunRay 170 has two embedded serial ports. When internal smart card reader service is disabled, users cannot access the internal smart card reader through the PC/SC or SCF interfaces for reading or writing; however, this does not affect session access or hotdesking with unauthenticated smart cards. When USB service is disabled, users cannot access any devices connected to USB ports. This does not, however, affect HID devices such as the keyboard, mouse, or barcode reader.