AMH SNF Queue Messages Test

SWIFT supports the use of input channel for InterAct messages in store-and-forward (SnF) mode. An input channel can be used by the messaging interface to establish an input session with SWIFT. The input session starts when the messaging interface opens the input channel and ends when the messaging interface closes the input channel. The input channel also supports sender-to-receiver first-in-first-out (FIFO) queue, which means that each message is delivered only one time and minimizes the number of possible duplicates.

This test monitors the queue messages and reports the current status of the SnF messages so that administrators are aware about the channel health and are able to take informed decision about workload processing.

Target of the test : A Swift AMH messaging hub

Agent deploying the test : An internal agent

Outputs of the test : One set of results for each SNF Queue message service operating on the target Swift AMH being monitored.

Configurable parameters for the test

Parameter

Description

Test period

How often should the test be executed

Host

The host for which the test is to be configured.

Port

The port at which the specified host listens.

SSL

If the JBoss AS/EAP server being monitored is an SSL-enabled server, then set the SSL flag to Yes. If not, then set the ssl flag to No.

JMX Remote Port

Specify the port at which the JMX listens for requests from remote hosts. Ensure that you specify the same port that you configured in the management.properties file in the <JAVA_HOME>\jre\lib\management folder used by the target application Java Applications chapter.

JNDI Name

Specify the lookup name for connecting to the JMX connector of the Swift AMH.

JMX User, JMX Password and Confirm Password

These parameters appear only if the Measurement Mode is set to jmx. If JMX requires authentication only (but no security), then ensure that the JMX User and JMX Password parameters are configured with the credentials of a user with read-write access to JMX. To know how to create this user, refer to the How to Monitor JBoss Application Server Using eG Enterprise? chapter. Confirm the password by retyping it in the Confirm Password text box.

JMX Registry SSL

If you have registered the JMX connector in an SSL-enabled RMI registry , set this flag to Yes. By default, this is set to No.

Measures made by the test

Measurement

Description

Measurement Unit

Interpretation

Status

Indicates the current status of SNF Queue messages.

 

The numeric values that correspond to these measure values are as follows:

Measure Value Numeric Value
Open 4
Connected 5
Active 6
Ready 7
Starting 12
Stopping 13
Restarting 14
Recovering 15
Reconnecting 16
Recovered 32
Alerted 33
Partially Started 34
Disabled 42
Stopped 43
Not Active 44
Start Failed 52
Restart Failed 53
Stop Failed 54
Init Failed 55
Recovery Failed 56
Error 65

Note:

By default, this measure reports the Measure Values listed in the table above to indicate the status. In the graph of this measure however, the same is indicated using the numeric equivalents only.