Solace Voltage Sensors Test

This test auto-discovers the voltage sensors on the target Solace PubSub+ Event Broker and for each sensor, this test reports the current status. Using this test, administrators can easily figure out the sensors that are out of range, the sensors that detected high voltage passing through the hardware components etc and rectify the discrepancies before the sensors and the hardware components associated with the sensors fail.

Target of the test : A Solace PubSub+ Event Broker

Agent deploying the test : A remote agent

Outputs of the test : One set of results for each voltage sensor associated with the hardware components of the target Solace PubSub+ Event Broker

Configurable parameters for the test

Parameter	Description
Test Period	How often should the test be executed.
Host	The IP address of the target host for which this test is to be configured.
Port	Refers to the port at which the Solace PubSub+ Event Broker listens to.
UserName and Password	By default, the eG agent executes SEMP ( Solace Element Management Protocol) APIs on the target broker to collect the required metrics. For the eG agent to execute the SEMP APIs, a special user with read only privilege is required. Specify the credentials of such a user in the UserName and Password text boxes. To know how to create such a user, refer to Creating a New User for Monitoring Solace PubSub+ Event Broker.
Confirm Password	Confirm the Password by retyping it in the Confirm Password text box.
SSL	By default, this flag is set to No indicating that the Solace PubSub+ Event Broker is not SSL-enabled by default. Set this flag to Yes if the Solace PubSub+ Event Broker is SSL-enabled.

Measurements made by the test

Measurement	Description	Measurement Unit	Interpretation
Status	Indicates the current state of this voltage sensor.		The values reported by this measure and its numeric equivalents are mentioned in the table below: Measure values Numeric values Abnormal 0 Ok 1 Unknown 2 Note: By default, this measure reports the Measure Values listed in the table above to indicate the current state of each voltage sensor. The graph of this measure however, represents the status of each voltage sensor using the numeric equivalents only i.e., 0 to 2.
Current Voltage	Indicates the current voltage detected by this voltage sensor.	Volts	Ideally, the value of this measure should be within admissible range. A sudden/gradual increase/decrease in the value of this measure is a cause of concern as the hardware component associated with the voltage sensor may fail abruptly.