Infoblox Power Supply Test

This test reveals the current status of each power supply unit available in the target Infoblox appliance. Using this test, administrators can easily identify the power supply units that have failed.

Target of the test : An Infoblox appliance

Agent deploying the test : An external agent

Outputs of the test : One set of results for each PSU in the Infoblox appliance that is to be monitored.

Configurable parameters for the test

Parameter	Description
Test Period	How often should the test be executed.
Host	The IP address of the Infoblox appliance for which this test is to be configured.
Timeout	Specify the duration (in seconds) within which the SNMP query executed by this test should time out in this text box. The default is 60 seconds.
Is Debug Enabled	By default, this flag is set to No. If you wish to obtain troubleshooting logs for this test, then, set this flag to Yes. The troubleshooting log with the naming convention <Component Name_Internal name of the test>.log will be created in the <eG_INSTALL_DIR>\agant\logs folder once the test starts reporting metrics.

Measurements made by the test

Measurement	Description	Measurement Unit	Interpretation
Status	Indicates the status of this PSU in the target appliance.		The values reported by this measure and their numeric equivalents are available in the table below: Measure Value Numeric Value Failed 0 Not present 1 Ok 2 Note: This measure reports the Measure Values listed in the table above to indicate the status of this PSU. However, in the graph, this measure is indicated using the Numeric Values listed in the above table.